Husqvarna SMS 125 2011, Руководство по ремонту

Страница: 182 / 258

J.8
CR 125 2011 - WR 125 2011
H06895
2
1
H06903
1
2
3
A
REAR SUSPENSION
Workshop Manual Ed. 06-2011
Servicing the swinging arm shaft
Check shaft taper using a dial gauge. Place the shaft on two identical reference
blocks. Turn the shaft and move the dial gauge horizontally to determine the
amount of distortion.
Service limit: 0.30 mm.
Servicing the rear suspension drop and drag link
With drop link (1) and drag link (2) still in place (connected to swinging arm and
chassis, respectively), rock them both back and forth in all directions to check for
radial and axial clearance. Some axial clearance in the drop drag link is required
for the swinging arm to achieve the ideal position for proper operation. If any
radial clearance is detected, remove the part from swinging arm or chassis, and
check inner spacers and bearings for wear.
Grease the inner race of the bearings before refitting them.
Chain roller, chain guide, chain slider
Check the wear of the above-mentioned elements and replace them when
necessary.
Check the chain guide alignment, and remember that a bent element
can cause chain early wear. In this case, chain might unwrap from
the sprocket.
1 Chain roller
2 Chain guide
3 Chain slider
A Master link clip