Husqvarna SG11, Руководство оператора

Страница: 37 / 48

English – 35
LUBRICATION
2. Engine oil
The engine should be warm (but not hot) when
changing the oil. Warm oil flows out faster and
leaves a smaller quantity of old oil inside the engine.
1. Place a suitable vessel underneath the oil
drainage screw. Remove the oil dipstick (1)
and the oil drainage screw (5) on the back
surface of the engine.
Tip: Make a channel using a piece of cardboard to
lead the oil directly into the vessel and avoid soiling
the machine chassis.
2. Allow the engine oil to drain into the vessel;
then replace the drainage screw. Tighten it
moderately.
IMPORTANT INFORMATION
Used engine oil is a health hazard and
legislation prohibits disposal on the ground
or in nature; it should always be disposed of
at a workshop or appropriate disposal
location. Avoid skin contact; wash with soap
and water in case of spills.
3. Make sure the machine is parked on even
ground. Fill the new oil using the appropriate
viscosity according to the diagram, API Service
SF-SG, to the upper level mark on the dipstick
= threads on the oil dipstick (2). The engine
takes 1.1 liters/1.16 US qt of oil. When
checking the oil level, the dipstick should not
be screwed in.
4. Check that the rubber gasket is in position and
screw the dipstick back into place. Do not
tighten it askew or too hard or you may
damage the threads.
5. Wipe up any spilled oil.
Checking the engine’s oil level.
Make sure that the machine is parked on even
ground with the engine stopped when checking the
oil level.
1. Unscrew the dipstick and wipe it using paper
towel or a lint-free rag.
2. Replace the dipstick without screwing it in.
Remove and check the level on the dipstick.
3. Fill oil as necessary to the lip of the dipstick
hole. Oil type, see above.
4. Check that the rubber gasket is in position and
screw the dipstick back into place. Do not
tighten it askew or too hard or you may
damage the threads.
WARNING!
Engine oil can be very hot if it is
drained directly after stopping the
machine. Allow the engine to cool
somewhat.
8011-187
8011-045
8011-046
8011-020