Husqvarna Rider 213C, Руководство оператора

Страница: 14 / 128

To stop the engine
1. Pull the lift lever for the cutting deck rearward to its
locked position to lift up the cutting deck. The blades
stop to rotate.
2. Turn the ignition key to the STOP position.
3. When the product stops, apply the parking brake.
To apply and release the parking brake
1. Press the parking brake pedal down (1).
2. Press and hold the lock button (2).
1
2
3. Keep the button pressed and release the parking
brake pedal.
4. To release the parking brake, press the parking
brake pedal again.
To get a good cutting result
• Do not cut a wet lawn. Wet grass can give a bad
cutting result.
• Start with a high cutting height and decrease it
gradually.
• Cut with blades that rotate at high speed (highest
permitted engine speed, see
Technical data on page
28
). Move the product forward at low speed. If the
grass is not too high and thick, you can get a good
cutting result also at a higher speed.
• To get the best cutting result, cut the grass
frequently and use the BioClip function.
Maintenance
Introduction
WARNING: Before you do any maintenance
work you must read and understand the
safety chapter.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's
manual. Let an approved service agent do the
maintenance.
Note: If more than one time interval is identified in the
table, the shortest time interval is for the first
maintenance only.
Maintenance Daily maintenance
before operation
Maintenance interval
in hours
25 50 100 200
Make sure that nuts and screws are tightened *
Make sure that there are no fuel or oil leaks *
Clean as given in To clean the product on page 15 X
Clean the inner surface of the cutting deck, around the blades X
Clean around the muffler X
Make sure that the cold air intake of the engine is not blocked X
Make sure that the safety devices are not defective X
Examine and do a test of the brakes *
14 374 - 001 - 29.09.2017