Husqvarna Rider 213C, Руководство оператора

Страница: 15 / 128

Maintenance Daily maintenance
before operation
Maintenance interval
in hours
25 50 100 200
Do a check of the engine oil level X
Do a check of the oil level in the transmission X
Do a check of the steering wires X
Examine the blades in the cutting deck X
Clean the cutting deck, below the belt covers and below the cutting
deck
X
Make sure that the tire pressure is correct X X
Do a check of the parking brake X
Change the engine oil X X
Change the oil filter X X
Clean the air filter X
Change the air filter X
Change the fuel filter X
Do a check of the parallelism of the cutting deck X X
Lubricate the belt adjuster. X X
Examine and adjust the steering wires O O
Examine the muffler and heat deflector O
Examine the cutting deck for damages O
Change the spark plug O
Adjust the parking brake. O
Do a check of and adjust the throttle wire O
Clean the cooling fins on the engine and the transmission O
Clean the engine and the transmission O
Do a check of the belts O O
Do a check of the battery * O
Do a check of the fuel hose. Replace it if necessary O
Change the oil in the transmission O O
To clean the product
CAUTION: Do not use a high pressure
washer or a steam cleaner. Water can go
into bearings and electrical connections and
cause corrosion which cause damage to the
product.
Clean the product directly after use.
• Do not clean hot surfaces such as the engine,
muffler and exhaust system. Wait until the surfaces
are cool, then remove the grass or dirt.
• Before you clean with water, clean with a brush.
Remove grass cuttings and dirt from on and around
the transmission, the transmission air intake, and the
engine.
• Use running water from a hose to clean the product.
Do not use a high pressure.
374 - 001 - 29.09.2017 15