Maintenance
Daily maintenance be-
fore operation
Maintenance in-
terval in hours
25
50
100
Clean the air filter
X
Replace the air filter
X
Replace the fuel filter
X
Replace the spark plug
X
Do a check of the parallelism of the cutting deck
X
X
Lubricate the belt adjuster.
X
X
Lubricate according to the lubrication overview
O
O
Lubricate all joints and shafts.
O
O
Examine and adjust the steering wires
O
O
Examine the muffler and heat deflector
O
O
Examine the cutting deck for damages
O
Adjust the parking brake.
O
Do a check of and adjust the throttle wire
O
Clean the cooling fins on the engine and the transmission
O
Clean the engine and the transmission
O
O
Do a check of the belts
O
O
Do a check of the battery
*
O
Do a check of the fuel hose. Replace it if necessary
O
Replace the oil in the transmission
O
O
Replace the filter in the transmission
O
O
To clean the product
CAUTION:
Do not use a high-pressure
washer or a steam cleaner. Water can go
into bearings and electrical connections and
cause corrosion which causes damage to
the product.
Clean the product immediately after use.
• Do not clean hot surfaces such as the engine,
muffler and exhaust system. Wait until the surfaces
are cool, then remove the grass or dirt.
• Before you clean with water, clean with a brush.
Remove grass cuttings and dirt on and around the
transmission, the transmission air intake, and the
engine.
• Use running water from a hose to clean the product.
Do not use high pressure.
• Do not point the water at electrical components or
bearings. Detergent usually increases the damage.
• To clean the cutting deck, put it in the servicing
position and clean it with a water hose.
• When the product is clean, start the cutting deck for
a short period to blow off remaining water.
16
1590 - 001 - 11.12.2020
