Husqvarna Platinum 3000, Руководство пользователя

Страница: 10 / 34

10
Attaching Thread Stand
Your
Platinum
TM
3000 comes equipped with a 4 spool thread stand. The thread stand can be used
to hold additional thread such as; bobbin thread, so you can wind bobbins at the same time you are
quilting. It is recommend that the thread stand telescoping pole be extended fully in order for the
thread to flow evenly and smoothly.
1. Locate the 2 screws on the machine next to the cable cover. Loosen screws, but do NOT
remove, so that thread stand can slide over screws (fig. 18).
2. Slide thread stand over the screws and tighten screws to hold stand in place.
3. Place the telescoping thread tree into the hole in the center of the thread stand. Use the supplied
screw and washer to secure the thread tree to the underside of the thread stand.
4. Extend the telescoping thread tree to its highest position (fig. 19)
Connect to Power Supply
1. Plug in the power cable to the power outlet located at the back of the machine (fig. 20).
2. Plug in the encoder cables into the identified “encoder” ports located at the back of the machine
(fig. 21).
Thread Stand
Fig. 18 Fig. 19
Fig. 20 Fig. 21