Husqvarna PG680, Руководство оператора

Страница: 28 / 200

0
SPEED
0
m/s
12:45 Jan 05
0
POWER
ON
REV FWD
OK
0
SPEED
0
POWER
REV FWD
4 4 1
• Frequency: How fast the oscillation is.
In amplitude mode, the "OK" button starts the
frequency mode. The arrow keys let you adjust the
frequency value.
0
SPEED
0
m/s
12:45 Jan 05
0
POWER
ON
REV
FWD
OK
0
SPEED
0
POWER
REV FWD
4 4 1
• In frequency mode, the "OK" button goes back to the
oscillation "ON"/"OFF" mode.
To operate the product with the remote
control
WARNING: Make sure that you can see the
product at all times when you operate it with
the remote control. The operation range of
the remote control makes it possible to move
the product also when you cannot see it.
Risk of injury and damage.
To do a pairing operation
The first time the remote control is used together with
the product, a pairing operation is necessary.
A pairing operation is also necessary if the remote
control is replaced or if you change remote controls
between products.
1. Make sure that the emergency stop buttons on the
control panel and on the remote control are
disengaged. Refer to
To do a check of the
emergency stop button on the control panel on page
12 and To do a check of the of the emergency stop
button on the remote control on page 13
.
2. Connect the power cord and start the product.
3. Connect the CAN bus cable. Refer to
To connect the
remote control to the product with a CAN bus cable
on page 28
.
4. Wait until the remote control is fully charged and the
main menu shows on the display.
5. Push the "OK" button to open the menu system.
6. Select "SETTINGS" and push the "OK" button.
PAIR RADIO
RADIO CHANNEL
[3]
12:45 Jan 05
LANGUAGE
[ENGLISH]
STOP WATCH SETTINGS
12:45 Jan 05
SERVICE
7. Use the arrow keys to go down to "PAIR RADIO"
and push the "OK" button.
8. A message on the display shows if the pairing
operation is done correctly. Do the procedure again
if the pairing operation is not done correctly.
To connect the remote control to the product
with a CAN bus cable
1. Put one end of the CAN bus cable in the connector
on the remote control.
28 1163 - 004 - 01.10.2020