There is no radio communication between
the remote control and the receiver.
The temperature of the hydraulic oil is too
high. The engine stops.
To start the product (LH 804)
WARNING: Keep your feet away from the
product during the start procedure. The
hydraulic system can cause the product to
move suddenly when the engine starts.
CAUTION: Do not use start gas. Start gas
can decrease the life of the engine.
1. Open the rear cover and remove the remote control
from the transport position.
2. Put the lever for the battery switch in the battery
switch (A).
A
B
Note: The lever for the battery switch hangs on a
chain behind the rear cover.
3. Turn the battery switch to the locked position to
engage the battery. The buzzer (B) operates until the
engine starts.
4. Close the rear cover and pull out the emergency
stop button.
5. Turn the start/stop button (C) clockwise to start the
remote control.
D
E
C
F
6. Push the button (D) to connect the remote control to
the receiver.
Note: If the remote control is used for the first time, it
is necessary to do a pairing operation. Refer to
do a pairing operation between the remote control
.
7. Move the switch for engine speed (E) down to low
speed.
8. Push the start/stop switch (F) up to start the engine.
Release the start/stop switch when the engine starts.
The buzzer stops.
CAUTION: If the engine does not start,
wait 3 seconds before you try again. If
the starter motor is operated for more
than 20 seconds, it cannot be started for
8 seconds. This prevents overload in the
starter motor. You must wait 8 seconds
before you can try to start the engine
again.
Note: The battery capacity is specified for 25°C/77°F
and the battery capacity decreases when the
temperature is lower. The battery capacity is not fully
decreased when cold, and it has full capacity again
when it becomes warm.
9. Examine the state of charge of the remote control
battery. Refer to
Remote control battery on page 13
.
To stop the product (LH 804)
1. Park the product on level ground.
2. Release the joystick (A) to stop the vibration.
B
C
A
3. Move the switch for engine speed (B) down to low
speed.
4. Let the engine operate at idle speed for 2–3 minutes.
1177 - 001 - 02.04.2020
17
Содержание LH 700
