Husqvarna K 6500 II Ring, Руководство оператора

Страница: 21 / 124

STARTING AND STOPPING
English
–
21
Before starting
• Connect the machine to the power unit.
• Connect the power unit to a grounded outlet
Residual-current device
• Make sure the ground fault circuit interrupter is
switched on.
Check the ground fault circuit interrupter. Refer to
instructions in the power unit operator’s manual.
Water connector
• Connect the water hose to the water supply.
• When the throttle lockout (1) is depressed, the water
valve will open.
Starting
• Grip the rear handle with your right hand.
• Depress the throttle lockout and hold in the throttle.
• Run the machine unloaded and in a safe manner for
at least 30 seconds.
Stopping
• Stop the motor by releasing the throttle.
• The motor can also be stopped by pressing the
emergency stop button or turning the switch to OFF
(0) on the power unit.
Turn off the tool.
• Allow the blade to stop completely.
• Unplug the power unit from the grid.
!
WARNING! Note the following before
starting:
Please read the operator’s manual
carefully and make sure you understand
the instructions before using the
machine.
Wear personal protective equipment. See
under heading ”Personal protective
equipment”.
Check that the mains voltage
corresponds with that stated on the
rating plate on the machine’s power
pack.
The machine’s power unit must be
connected to an earthed outlet socket.
Make sure you have a secure footing and
that the blade cannot touch anything.
Keep people and animals well away from
the working area.
!
WARNING! Never use the machine
without the accompanying RCD.
Carelessness can result in serious
personal injury or even death.
CAUTION! Never operate the machine without coolant
as this will cause overheating.
!
WARNING! The blade continues to rotate
for up to 10 seconds after the motor has
been turned off.