Husqvarna HP310-1, Руководство оператора

Страница: 223 / 247

5.
6.
Remove the sealing ring on one of the earmuffs. Put
the cable through the headband and put the cable in
the correct position.
Attach the cable behind the plastic clips on the inner
side of the helmet. (Fig. 21)
To put the earmuffs in operation position
1. Put the helmet on your head.
2. Adjust the earmuffs until they are tight around your
ears and tight against your head. (Fig. 22)
To put the earmuffs in standby position
• Lift the earmuffs out and up until they lock in standby
position. (Fig. 21)
To put the earmuffs in parking position
1. Put the earmuffs in standby position.
2. Turn the earmuffs rearward along the side of the
helmet until they lock in the parking position. (Fig.
24)
To assemble the boom microphone
Use a boom microphone in environments with much
noise. A boom microphone decreases the noise during
phone calls and two-way radio calls.
Note: A boom microphone is not supplied with the
product but is available as an accessory. Refer to
www.husqvarna.com for more information.
1. Make sure that the product is off.
2. Connect the boom microphone to the microphone
input on the right earmuff. (Fig. 25)
Operation
Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.
To charge the product
Note: The product is not supplied with a charger but you
can purchase a separate charger. You can also
purchase a replacement charger cable as an original
spare part. The Husqvarna part number: 594 95 63-01.
Refer to www.husqvarna.com for more information.
1. Connect the charger cable to the outlet on the left
earmuff. (Fig. 26)
2. Connect the USB connector on the charger cable to
a USB charger or computer USB port. A beep sound
tells you that the product charges.
3. Charge the product for a minimum of 4 hours to get
maximum battery capacity. If you charge the product
for 1 hour, you get 8 hours of operation.
To start the product
Note: The product always starts in FM radio mode.
1. Push and hold the On/Off/Mode button for 3
seconds.
2. Audio messages tell you about the status of the
product. Refer to the table below.
Audio mes-
sage
Information
POWER ON The product is on.
Audio mes-
sage
Information
BATTERY
LEVEL FULL
The battery is full.
BATTERY
LEVEL 75%,
BATTERY
LEVEL 50%,
BATTERY
LEVEL 25%
The charge level of the battery.
BATTERY
LEVEL LOW
The charge level of the battery is low.
RADIO The product is in FM radio mode.
CONNECTED The product is connected to a device
with
Bluetooth
®
wireless technology.
To change between FM radio mode and
Headset mode
1. Push the On/Off/Mode button for 1 second to change
between FM Radio mode and Headset mode.
2. Audio messages tell you about the status of the
product. Refer to the table below.
Audio mes-
sages
Information
RADIO The product is in FM radio mode.
HEADSET The product is in Headset mode.
FM radio mode
In FM radio mode you get access to FM radio.
579 - 005 - 05.07.2019 223