Husqvarna FE 450, Руководство пользователя

Страница: 48 / 128

12 SERVICE WORK ON THE CHASSIS
46
Warning
Danger of accidents
Oil or grease on the brake discs reduces the brak-
ing effect.
–
Always keep the brake discs free of oil and grease.
–
Clean the brake discs with brake cleaner when necessary.
–
Clean and oil the dust boots and inner fork tubes of both fork legs.
Universal oil spray ( p. 118)
–
Press the dust boots back into their normal position.
–
Remove excess oil.
Finishing work
–
Install the fork protector. ( p. 46)
–
Remove the motorcycle from the lift stand. ( p. 45)
12.5 Removing the fork protector
F00316-10
–
Remove screws  and take off the clamp.
–
Remove screws

on the left fork leg and take off the left fork protector.
–
Remove screws

on the right fork leg and take off the right fork protector.
12.6 Installing the fork protector
F00316-11
–
Position the fork protector on the left fork leg. Mount and tighten screws

.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
–
Position the brake line, wiring harness, and clamp. Mount and tighten screws  .
–
Position the fork protector on the right fork leg. Mount and tighten screws

.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
12.7 Removing the fork legs
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the headlight mask with the headlight. ( p. 89)
–
Raise the motorcycle with a lift stand. ( p. 45)
–
Remove the front wheel. ( p. 80)
F00274-10
Main work
–
Remove screws

and take off the clamp.
–
Remove the cable tie(s).
–
Remove screws

and take off the brake caliper.
–
Allow the brake caliper and brake line to hang loosely to the side.