Husqvarna FC 250 2017, Руководство пользователя

Страница: 36 / 114

10 TUNING THE CHASSIS
34
10.16 Handlebar position
H01188-10
The holes on the handlebar supports are placed at a distance of

from the center.
Hole distance A 3.5 mm (0.138 in)
The handlebar can be mounted in 2 different positions. In this way, the handlebar can
be mounted in the most comfortable position for the rider.
10.17 Adjusting the handlebar position
Preparatory work
–
Remove the handlebar cushion.
H01189-11
Main work
–
Remove screws

. Take off the handlebar clamp. Take off the handlebar and lay
it to one side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
–
Remove screws

. Take off handlebar supports

.
–
Position rubber bushings

and push through nuts

from below.
–
Place the handlebar supports in the required position.
Info
The handlebar supports are longer and higher on one side.
Position the left and right handlebar supports evenly.
–
Mount and tighten screws  .
Guideline
Screw, handlebar support M10 40 Nm
(29.5 lbf ft)
Loctite ® 243™
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned correctly.
–
Position the handlebar clamp.
–
Mount screws

but do not tighten yet.
–
First bolt the handlebar support with screws

onto the longer, higher side of
the handlebar supports so that both parts touch.
–
Tighten screws  evenly.
Guideline
Screw, handlebar clamp M8 20 Nm (14.8 lbf ft)
Finishing work
–
Mount the handlebar cushion.