Husqvarna F2303V7, Руководство пользователя

Страница: 124 / 170

16 COOLING SYSTEM
122
–
Allow the engine to warm up and cool down again.
–
Check the coolant level. ( p. 119)
Finishing work
–
Install the engine guard. ( p. 86)
16.6 Changing the coolant
Warning
Danger of scalding
During motorcycle operation, the coolant gets very hot and is under pressure.
–
Do not open the radiator, the radiator hoses or other cooling system components if the engine or
the cooling system are at operating temperature.
–
Allow the cooling system and the engine to cool down before you open the radiator, the radiator
hoses or other components of the cooling system.
–
In the event of scalding, rinse the area affected immediately with lukewarm water.
Warning
Danger of poisoning Coolant is toxic and a health hazard.
–
Keep coolant out of the reach of children.
–
Do not allow coolant to come into contact with the skin, the eyes and clothing.
–
Consult a doctor immediately if coolant is swallowed.
–
Rinse the affected area immediately with plenty of water in the event of contact with the skin.
–
Rinse eyes thoroughly with water and consult a doctor immediately if coolant gets into the eyes.
–
Change clothing if coolant spills onto your clothing.
H03759-11
–
Place an appropriate container under the water pump cover.
–
Remove screw
1
. Take off radiator cap
2
.
–
Completely drain the coolant.
–
Mount and tighten screw
1
with a new seal ring.
Guideline
Screw, water pump
cover M6 10 Nm (7.4 lbf ft)
–
Position the motorcycle upright.
–
Completely fill the radiator with coolant.
Coolant ( p. 156)
S04263-10
–
Push protection cap
3
upward over the coolant tempera-
ture sensor.