Husqvarna F1103V5, Руководство пользователя

Страница: 80 / 133

14 WHEELS, TIRES
78
F02843-10
–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
Change the rear wheel bearing.
–
Clean and grease shaft seal rings
1
and contact
surfaces
A
of the spacers.
Long-life grease ( p. 123)
–
Clean the thread of the wheel spindle and axle nut.
–
Clean and grease the wheel spindle.
Long-life grease ( p. 123)
–
Clean the contact areas on the brake caliper bracket and link
fork.
–
Mount the damping rubber pieces and rear sprocket carrier
on the rear wheel.
–
Insert the narrow spacer into the side of the rear sprocket.
–
Insert the wide spacer into the side of the brake disc.
–
Position the rear wheel.
The brake linings are correctly positioned.
–
Push the rear wheel forward as far as possible and lay the
chain on the rear sprocket.
F02824-12
–
Pull the rear wheel back and mount wheel spindle
3
with
the washer and chain adjuster
4
.
Guideline
Mount left and right chain adjusters
4
in the same posi-
tion.
–
Mount nut
2
with the washer.
–
Make sure that the chain adjusters are fitted correctly on the
screws.
–
Check the chain tension. ( p. 64)
–
Tighten nut
2
.
Guideline
In order for the rear wheel to be correctly aligned, the
markings on the left and right chain adjusters must be in
the same position relative to reference markings
B
.
Nut, rear wheel spin-
dle
M14x1.5 90 Nm (66.4 lbf ft)
–
Position wheel speed sensor
5
in the hole.
–
Mount and tighten screw
6
.
Guideline
Screw, wheel
speed sensor
M6 7 Nm (5.2 lbf ft)
Loctite
®
243™
Finishing work
–
Remove the rear of the motorcycle from the lifting gear.
( p. 51)