Husqvarna DM 230, Руководство оператора

Страница: 19 / 100

Problem Steps to do im-
mediately
Possible cause Solution
The product does not con-
tinue into the surface, de-
creases in speed and stops.
Release the
power switch.
The diamond segments are
blunt.
Sharpen the diamond segments
with a SiC grind stone.
Unwanted material collects
around the hole during oper-
ation.
The water pressure is too
low.
Increase the water pressure. Refer
to
Technical data on page 20
.
The diamond segments on
the drill bit are pulled out of
their bond.
There are much vibration in
the product during the oper-
ation.
Use correct load when you operate
the product.
There is a leakage of gear
oil.
The seals are worn out and
must be replaced.
Speak to an approved Husqvarna
service center.
There is a leakage of water
from the hole on the water
connection ring.
The shaft seals are defect. Speak to an approved Husqvarna
service center. Make sure to always
use clean water.
The product does not oper-
ate smoothly.
Decrease the
force.
Too high load causes over-
load of the motor.
Use less force when you drill.
Transportation and storage
• Pull out the plug from the power outlet before
transportation or storage of the product.
• Remove the drill bit before transportation or storage
of the product. This is to prevent damage to the
product and the drill bits.
• Keep the product in a locked area to prevent access
for children or persons that are not approved.
• Keep the product in a dry and frost-free area.
• Safely attach the product during transportation to
prevent damage and accidents.
1473 - 001 - 04.04.2022 19