4. Tighten the washers (B) and nut (A) on the
rotation device screw.
5. Install the handle link (F). Check that the blocking
pins (G) engages the holes in the tube to lock
the handle and link firmly together.
F
G
G
For BV 20E
1. Attach the control unit to the handle with the
screws that are located under the control unit.
For BV 20G
1. Attach the speed control to the handle with a
clamp.
2. Attach the accelerator cable on the handle with
clips (H).
H
H
Preparations
BV 20E
1. Check the general condition of the equipment
and connectors and cables.
NOTICE
Replace any damaged part
immediately.
2. Only use insulated electrical extension cables
designed for outside use (type H07-RN-F).
3. Check that the power supply voltage and type of
current corresponds with the label on vibrator.
(See the label on the machine.)
4. The vibrator must be connected to a grounded
connector through a RCD-breaker.
5. For safety reasons the supply cable to the
machine must be shorter than 10 meters (32 ft.)
6. Make sure that the supply cable can run free
along the surface of the working area.
7. Never pull in the cable if it has been trapped. The
cable can be damaged if it gets caught.
BV 20G
1. Do not operate the motor in an area with
insufficient ventilation.
2. Make sure that no flammable material comes in
contact with the exhaust.
3. Check the fuel level.
4. Check the oil level and make sure that it is toped
up.
5. For more information See the manual for the
motor.
Refuelling
1. Do not smoke, stand near a flame or another
potential danger when refuelling.
2. Stop the motor and remove the fuel cap.
3. Refuel only with petrol.
4. Close the fuel valve before refuelling.
5. Always use a filter when refuelling.
6. Wipe up any spilled fuel before starting up the
motor.
General inspection
Before using the BV 20E:
1. Clean and inspect the machine and the functions
before use.
2. Check for damages.
Before using the BV 20G:
© 2015 Construction Tools EOOD | No. 9800 1189 01b | 2015-05-12
Original instructions
12
BV 20E, 20G
Safety and operating instructions
To
order
go
to
Discount-Equipment.com
