Husqvarna Automower 305, Техническое руководство

Страница: 32 / 94

English - 30
3.3 Guide wire
3.3.1 Installation of the guide wire
• Check that the charging station is in the best
position.
• The position of the charging station and
where the guide wire is connected along the
boundary wire has an impact on how long
the guide loop will be, see “1.11 Guide wire”
on page 12 .
The illustration below shows how a guide
loop can look.
The illustration is also a good example of a
good charging station position that results in
the shortest possible guide loop.
• Make the guide loop as short as possible. If
the guide loop is longer than 250 m it may be
hard for the mower to follow the wire.
If the guide wire must be laid in a passage:
• The robotic lawnmower follows the guide wire
on the same side of the wire to and from the
charging station. This means that the guide wire
is to the right of the mower on its way to the
charging station and to the left of the mower on
its way from the station.
• In the passage, the guide wire must be
placed so that the mower has enough
space to operate in. The distance between
the boundary wire and the guide wire
should be at least 30 cm.
• The same shortest distance (30 cm) also
applies to the distance between the guide
wire and the guide wire in the passage if
the guide wire is laid back and forth through
the passage.
The guide wire must the connected to the charging
station. If it is laid at a right angle in the working
area at a distance in front of the charging station,
the distances in the following illustration must be
observed.
If the mower collides with any obstacle while it
follows the guide wire to the charging station, it will
turn away from the guide wire and again try to find
the guide wire. It then decides to follow the guide
wire at another distance.
3. INSTALLATION
3012-949
3020-012
min 1,5m min 2m
3012-950
3012-952