Husqvarna Automower 305, Техническое руководство

Страница: 31 / 94

English - 29
Twinned wires, or a screw terminal
block (chock-block), that is insulated
with insulation tape are not satisfactory
splices. Soil moisture will cause the
connections to oxidise and after a while
result in a broken circuit.
IMPORTANT INFORMATION
The robotic lawnmower interprets an odd number of
wires next to each other as an outer edge where it
has to turn. The mower will however run over an even
number of wires close to each other.
If the wires to and from an obstacle are crossed, the
robotic lawnmower can interpret that it is outside the
working area despite it being inside the working area.
If the obstacle is also relatively large compared to the
working area, it may have an impact on the mower
inside the entire working area.
Obstacles within the working area that can be run into
should still be demarcated by the boundary wire even
though the function of the robotic lawnmower does
not demand this. It will however make operations
quieter and significantly reduce wear on the robotic
lawnmower. Obstacles that can withstand a collision
include large trees, large kerbstones, swing frames,
sandboxes, walls, thick bushes, etc.
Couplers
If the supplied boundary wire is not long enough
to cover the entire working area, extra wire can be
added using an original coupler. The total length of
the boundary loop should not exceed 300 metres
(250 metres for 305 and R40Li).
To join boundary wires:
1. Insert both wire ends in the coupler. Check
that the wires are fully inserted into the
coupler so that the ends are visible through
the transparent area on the other side of
the coupler.
2. Now press down the button on top of the
coupler fully. Use a pair of pliers if the
button on the coupler is difficult to press
down by hand.
3012-944
3012-643
3012-686
3018-055
3. INSTALLATION