9
INSTALL HANGER BRACKETS AND SHOULDER
BOLTS TO OUTSIDE OF FRAME
STEP 11: (SEE FIGURE 9)
•
Remove the bolt, if present, in the hole directly behind
the brake rod on the left side of the tractor frame.
• Attach the L.H. Hanger Bracket (tube facing out) to the
hole using a 5/16" x 3/4" self threading bolt.
• Install a shoulder bolt into the hole that is 9-1/2" to the
rear of the bolt you just installed. Secure it with a 3/8"
flange nut on the inside of the frame.
FIGURE 9
LEFT SIDE VIEW
STEP 12: (SEE FIGURE 10)
•
Remove the bracket, if present, from the hole directly
behind the end of the brake rod on the right side of
the tractor frame. Store the bracket and bolt.
• Attach the R.H. Hanger Bracket to the hole using a
5/16" x 3/4" self threading bolt.
• Install a shoulder bolt into the hole that is 9-1/2" to the
rear of the bolt you just installed. Secure it with a 3/8"
flange nut on the inside of the frame.
FIGURE 10
RIGHT SIDE VIEW
5/16" x 3/4" SELF
THREADING BOLT
L.H. HANGER
BRACKET
BRAKE ROD
3/8" FLANGED NUT
SHOULDER
BOLT
5/16" x 3/4" SELF
THREADING BOLT
R.H. HANGER
BRACKET
RIGHT END OF
BRAKE ROD
3/8" FLANGED
NUT
SHOULDER
BOLT
FIGURE 6
LEFT SIDE VIEW
STEP 8: (SEE FIGURE 6)
• Route the wire harness along the left side of the tractor.
• Install two clamps onto the wire harness and attach
them to the bolts in the top cover of the winch using
two 5/16" nylock nuts.
5/16" NYLOCK NUTS
CLAMPS
3/8" NYLOCK JAM NUT
3/8" HEX NUT
CLAMP
STEP 9: (SEE FIGURE 7)
• Install a 3/8" hex nut all the way onto the 3/8" x 1-1/2"
bolt in the L.H. side plate.
• Install a clamp onto the the wire harness, just in front
of where the two wires separate from the corrugated
tubing. Attach the clamp to the 3/8" x 1-1/2" bolt using
a 3/8" nylock jam nut.
FIGURE 7
LEFT SIDE VIEW
STEP 10: (SEE FIGURE 8)
• Connect the wire harness to the winch motor, making
sure the connectors snap firmly together.
• Attach the wire harness to the rear of the side plate
using a plastic tie.
FIGURE 8
LEFT SIDE VIEW
CONNECTORS PLASTIC TIE
