Husqvarna 335XPT California, Руководство по ремонту

Страница: 16 / 44

16
– English
SAFETY EQUIPMENT
Chain catcher
Remove the chain and bar. See Operator's manual.
Check the spike (J) and chain catcher (K). Replace if the parts
are damaged. Bolts shall be tightened to 6 Nm.
Fit the chain and bar. See Operator's manual.
Inspection
Clean all parts and check the following:
1. That the spark arrester (C) is OK.
2. That the muffler and muffler mountings are not cracked or
show signs of other defects.
3. That the gasket (D) is OK.
Assembly
1. Place the chain saw in the fixture (see service tools) or in a
vice so that the muffler's contact surface on the cylinder is
positioned horizontally.
2. Place gasket (D) in position on the cylinder.
3. Carefully slide in the muffler without dislodging the gasket.
4. Press the muffler down onto the cylinder when the holes in
the muffler, gasket and cylinder are aligned. The gasket
can be adjusted using a small screwdriver.
5. Tighten the muffler's bolts to 8-10 Nm.
6. Fit the muffler guard.
A
A
D
C
B
B
B
D
K
J
Dismantling
Dismantle the muffler as follows:
1. Dismantle the muffler guard by unscrewing the two bolts
(A).
Muffler
!
2. Turn the saw and unscrew the three bolts (B) that hold the
muffler in position.
3. Lift out the muffler to the side.
4. Remove the gasket.
WARNING!
Do not touch the muffler until it has cooled.
Risk of burns.
Eng 10-18 97-12-03, 16.27 16