Husqvarna 331RB, Руководство по ремонту

Страница: 27 / 48

14. Hold the flywheel puller and loosen and remove the
flywheel nut.
15. Attach the center unit to the flywheel puller. Hold the
flywheel puller and use a wrench to tighten the
center bolt until the flywheel releases.
7.7.6 To assemble the ignition system
1. Put some grease on the clutch screw, but not on the
thread.
2. Make sure that the keyway in the flywheel and the
keyway in the crankshaft are not damaged. Make
sure that the key is not damaged.
3. Attach the flywheel and the centrifugal clutch with
the spacers and screws as shown in the illustration.
Note: Turn the clutch until you can see the arrows
that show the direction of rotation.
4. Assemble the cables to the ignition module. Use the
2 screws and the 2 washers to assemble the ignition
module on the frame.
1281 - 001 - Repair instructions - 27