Husqvarna 331RB, Руководство по ремонту

Страница: 14 / 48

4. Make a small knot on the starter rope and pull the
knot into the handle.
5. Tighten the recoil spring.
a) Pull out the starter rope fully and slow the starter
pulley with your thumb.
b) Lift the starter rope up and out of the groove on
the starter pulley. Turn the starter pulley
counterclockwise 4 turns.
c) Pull out the starter rope fully and turn the starter
pulley a minimum of a half turn more.
6. Attach the gasket and the starter with the 4 screws.
7. Tilt the starter slightly forward to make sure that the
starter is installed correctly on the cylinder cover and
on the muffler.
7.3.5 To replace the starter pawl assembly
1. Remove the starter. Refer to
To disassemble the
starter on page 12.
2. Remove the spark plug cap and the spark plug.
3. Put a piston stop in the spark plug hole to lock the
axle.
4. Loosen the nut. Remove the starter pawl assembly.
5. Examine the starter pawl assembly.
a) Clean the starter pawl assembly if it is dirty.
b) Replace the starter pawl assembly if it is
damaged.
6. Install the starter pawl assembly in the opposite
sequence.
14 - Repair instructions 1281 - 001 -