Husqvarna 1650EXLT, Руководство оператора

Страница: 11 / 28

11
OPERATION
The operation of any snow thrower can result
in foreign objects thrown into the eyes, which
can result in severe eye damage. Always wear
safety glasses or eye shields while operating
your snow thrower or performing any ad just-
ments or repairs. We recommend standard safe ty glasses
or a wide vision safety mask worn over spectacles.
HOW TO USE YOUR SNOW THROWER
Know how to operate all controls before adding fuel or
attempting to start the engine.
STOPPING
TRACTION DRIVE
• Release traction drive control lever to stop the forward
or reverse movement of the snow thrower.
AUGER
• Release the auger control lever to stop throwing snow.
ENGINE
1. Move ON / OFF switch to “OFF” position.
2. Remove (do not turn) safety ignition key to prevent
unauthorized use.
NOTE: Never use choke to stop engine.
FIG. 12
TRANSPORT AND HEIGHT ADJUSTMENT OF
SNOW THROWER
TO TRANSPORT (See Figs. 11 & 12)
When transporting your snowthrower, be sure to disen-
gage the transmission by placing freewheel control into
FREE WHEEL po si tion (See Fig. 11) and height adjustment
locator into TRANSPORT MODE position (See Fig. 12).
• Pull freewheel control out to FREEWHEEL position.
• Set height adjustment into TRANSPORT MODE.
• To reengage transmission, push control back in.
FREEWHEEL POSITION
FIG. 11
TRANSMISSION ENGAGED
SET HEIGHT ADJUSTMENT (See Figs. 12 & 13)
Your snow thrower is equipped with a foot controlled height
adjustment mechanism (See Fig. 13).
There are four height positions for operation (See Fig. 12)
1. PACKED SNOW
2. NORMAL OPERATION
3. TRANSPORT
4. FLOAT
To operate the height adjust mechanism, using your
foot, push down on the pedal, tilt the unit to align
the pins with the selected height position and slowly
release foot pressure until the pins are seated in the
desired height setting.
FIG. 13
IMPORTANT: Your model snow thrower is equipped
with an oil expansion tank attached to the hydrostat-
ic transmission (see fig. 13). As you run your snow
thrower, the oil level will rise in this tank as the oil
heats up and recess as the oil cools. This is normal
operation. You do not need to add oil to this tank as
part of regular maintenance.
NOTE: When you receive a new unit that has not been
run, the oil level in the expansion tank may be some-
where between the bottom of the tank and near the
top of the tank. After initial operation the oil level may
drop because of the elimination of air bubbles in the
oil line. Normal cold oil level is near the bottom of the
tank. Do not add additional oil.
PEDAL
OIL EXPANSION
TANK
FREEWHEEL
CONTROL