Husqvarna Viking Sapphire 835, Руководство пользователя

Страница: 15 / 56

15
1
A
B
C
A
B
C
D
Getting ready to sew
Winding the bobbin using the vertical
spool pin
1. Place an empty bobbin on the bobbin spindle on the top
of the machine. The bobbin only À ts on one way, with the
logo facing up. Use only original HUSQVARNA VIKING®
bobbins.
2. Place the large spool holder and a felt pad under the spool on
the main spool pin set in the vertical position.
3. Bring the thread over and behind the pre-tension thread
guide (A) and down around the thread tension disc (B), then
through thread guide (C) as illustrated.
4. Guide the thread through the hole in the bobbin (D) from the
inside to the outside.
5. Push the bobbin spindle to the right. A pop-up message
appears on the GraphicDisplay. Press the foot control to start
winding. Hold the end of the thread
À rmly when starting to
wind. Once the bobbin begins to wind, cut the excess thread.
When the bobbin is full, it will stop automatically. Push the
bobbin spindle back to the left, remove the bobbin and cut
off the thread on the thread cutter.
Winding the bobbin using the auxiliary
spool pin
1. Place an empty bobbin on the bobbin spindle on the top
of the machine. The bobbin only À ts on one way, with the
logo facing up. Use only original HUSQVARNA VIKING®
bobbins.
2. Fold out the auxiliary spool pin. Place a large spool holder and
a felt pad under the spool.
3. Bring the thread over and behind the pre-tension thread
guide (A) and down around the thread tension disc (B), then
through thread guide (C) as illustrated.
4. Guide the thread through the hole in the bobbin (D) from the
inside to the outside.
5. Push the bobbin spindle to the right. A pop-up message
appears on the GraphicDisplay. Press the foot control to start
winding. Hold the end of the thread
À rmly when starting to
wind. Once the bobbin begins to wind, cut the excess thread.
When the bobbin is full, it will stop automatically. Push the
bobbin spindle back to the left, remove the bobbin and cut
off the thread on the thread cutter.
NOTE:
Depending on the type of thread, wrap the
thread one or two turns around the bobbin thread
tension disc (B) to put more tension on the thread.
NOTE:
When using an earlier version of HUSQVARNA
VIKING® bobbins that do not have a hole, wind several
turns of thread on the bobbin to get started.