Husqvarna Viking Huskylock S25, Руководство пользователя

Страница: 29 / 52

3 – THREAD YOUR HUSKYLOCK™
S
25 27
NEEDLE THREADER
To make threading the needles easier, use the needle threader
included with the accessories.
Turn the handwheel so the needles are in their highest
position and lower the presser foot. Make sure one of the
rectangular markings of the needle threader is pointing
XSZDUGV3ODFHWKHWKUHDGIURPULJKWWROHIWLQWKHQRWFKRQ
the tip of the needle threader.
Hold the needle threader against the needle. Move the needle
threader down to the needle eye and press gently against the
needle, causing a small metal pin to push the thread through
the needle eye and form a thread loop.
Use the needle threader to pull the thread loop out behind
the needle.
CHANGE THREAD
The following is an easy way to change threads:
1. Cut the thread in use near the spool, behind the guides
on the telescopic thread stand.
2. Remove the thread spool and place the new thread on
the spool pin.
3. Tie the end of the new thread to the end of the old
WKUHDG&XWWKHWKUHDGWDLOVWRFPLQOHQJWKDQG
ÀUPO\SXOOERWKWKUHDGVWRWHVWNQRWVHFXULW\
4. Raise the presser foot to release the tension discs.
3XOOWKHWKUHDGVWKURXJKWKHPDFKLQHRQHDWDWLPHXQWLO
the knots are in front of the needle. If the threads do not
pull easily, check for tangles on thread guides or looping
under thread stand.
6. Cut the thread behind the knot and thread the needle.
1RWH:KHQXVLQJVWDQGDUGWKUHDGVSRROVSODFHWKHWKUHDGXQUHHOLQJ
GLVFDVVKRZQWRSUHYHQWWKHWKUHDGIURPJHWWLQJFDXJKWRQWKHHGJHRI WKH
VSRRO