Husqvarna Viking Designer Ruby Royale, Руководство пользователя

Страница: 115 / 134

E
MBROIDERY
S
TITCH
-O
UT
8:13
EMBROIDERY STITCH-OUT POP-UP
MESSAGES
Embroidery Unit Calibration
When the embroidery unit is attached, a pop-up message
asks you to slide off the hoop and clear the machine
DUHDIRUFDOLEUDWLQJWKHHPEURLGHU\DUP<RXZLOODOVREH
UHPLQGHGWRDWWDFKWKH6HQVRU4IRRW
Note: It is very important to remove the hoop, otherwise the hoop or
the embroidery unit may be damaged while calibrating.
Attach Correct Hoop
If the size of the hoop attached to the machine does not
match the size displayed on screen, the machine will not
HPEURLGHU<RXPXVWFKDQJHWKHKRRSWRWKHGLVSOD\HGVL]H
or change the hoop setting to match the hoop size attached.
The hoop needs to be inserted properly for the machine
WRGHWHFWLW6OLGHWKHKRRSFRQQHFWRULQWRWKHKRRS
attachment from front to back until it clicks into place.
<RXZLOOQRWEHDEOHWRJRWR(PEURLGHU\6WLWFK2XW
without the selected hoop attached properly.
Change Thread Color
When it is time to change the needle thread, the machine
stops and the upper thread is cut. Change the spool of
thread and re-thread the machine. The next recommended
color number is shown in the pop-up message.
Cut Thread End
After changing the thread, the machine will sew a few
stitches and then stop so you can cut the thread end.
Note: When Automatic Jump Stitch Trim is selected in the SET
menu, the thread end will be cut automatically. Simply remove the
thread tail that has been cut.
Bobbin thread low - move to bobbin position?
When the bobbin thread is running low, a pop-up message
appears giving you an advanced notice that you’ll soon need
to change the bobbin. This gives you an opportunity to
plan when you want to change your bobbin. If you want to
FRQWLQXHHPEURLGHULQJMXVWWRXFKWKH6WDUW6WRSEXWWRQRU
the foot control without touching the ok in the pop-up.
It is possible to embroider until the thread has completely
run out. Press the start/stop button to continue
embroidering without closing the bobbin thread low pop-
up. Touch cancel to remain at the current stitch position.
Touch OK to move the hoop to bobbin position. The hoop
position pop-up opens. Replace the empty bobbin with
a full one. Touch Current position and pull back excess
needle thread. Press start/stop or press your foot control to
continue embroidering.