Husqvarna Viking Designer I, Руководство пользователя

Страница: 11 / 117

11
Learn your Designer I
USB
Bobbin winding –
vertical spool pin
1. Place an empty bobbin with the mark out
on the bobbin spindle on the front of the ma-
chine. Bring the bobbin spindle down. A Pop-
up menu on the Color Touch Screen reminds
you that bobbin winding is engaged.
2. Place the large spool holder under the thread
on the spool pin.
3. Bring the thread around thread guide (b),
then under thread guide (c) and over (d) as
illustrated.
4. From above wind a few turns of thread clock-
wise around the bobbin and into the thread
cutter (e).
5. Press the foot control or touch . When
the bobbin is fi lled, the winding will stop au-
tomatically. Remove the bobbin, cut off the
thread (e) and bring the bobbin spindle up.
Note: Depending on the quality of the thread you
can wind the thread one or two times around the
threadguide (b) in order to get the right thread ten-
sion.
Placing the bobbin
in the machine
Turn off the main switch.
1. Open the cover by sliding it towards you and
remove it.
2. Place the bobbin in the bobbin case with
the mark facing up and the thread to the
left of the bobbin. The bobbin will then ro-
tate counter clockwise while pulling out the
thread.
3. Place your fi nger on the bobbin to keep it
from turning as you pull the thread fi rmly to
the right and then to the left into the tension
spring (a) until it “clicks” into place.
4. Continue threading around (b) and to the
right of the thread cutter (c). Replace the cov-
er with the lines to the front and slide it into
position (1). Then pull the thread to the left
to cut it (2).
10 15
1.
2.
4. 3.
b
c
e
d
a
b
1
2
b
c