12
If within two years from the date of purchase, this Husky air tool product fails due to a defect
in materials or workmanship, please immediately contact Product Support at 1-888-669-
5672 (8am to 5pm EST, M-F, except normal Holiday).Do not return the air tool to the store.
Please be prepared to send the product, postage prepaid, along with a copy of the dated
first owner purchase receipt with the tool
model to: PRIME GLOBAL PRODUCTS, INC.
Address:201 Ropemill Parkway, suite#1, Woodstock, GA.
30188. A
defective
product
will
be
promptly
replaced
with
a
new
one
of
equal
or
greater
value. This
warranty
excludes
incidental/consequential
damages
and
failures
due
to
misuse,
abuse or normal wear and
tear. This warranty gives you
specific rights, and you
may also have other rights, which vary, from state to state. Please call
for
details.
1-888-669-5672
WARRANTY
2 YEARS LIMITED WARRANTY
TROUBLE SHOOTING
PROBLEMS
POSSIBLE CAUSES
CORRECTION ACTIONS
Air leaking in head cap.
⒈
Loose screws.
⒉
Worn or damaged O-rings or seals.
⒈
Tighten screws.
Install overhaul kit.
⒉
Lack of power.
Slow to cycle.
⒈
Tool is too dry.
Air pressure too low.
Exhaust blocked.
⒉
⒊
⒈
Add about 2-3 drops of
lubrication into the air connector.
⒉
Make sure the air compressor
is set between 70psi and 115psi.
Clean exhaust channel.
⒊
Not shooting fasteners .
⒈
Damaged pusher spring.
Wrong size of fasteners.
⒉
⒈
Replace spring.
⒉
Use 1/2" crown staples or
1-1/2" to 2"nails.
⒈
Fix the drive channel.
Replace the piston.
Remove the bent fasteners,
replace with the 1/2"crown
staples or 1-1/2" to 2"nails.
Clean magazine.
Tighten screws.
Verify that fasteners are the
correct size.
⒉
⒊
⒋
⒌
⒍
⒈
Drive channel is worn.
Piston is broken or worn.
Bent fasteners.
Dirty magazine.
Loose magazine.
Wrong fasteners.
⒉
⒊
⒋
⒌
⒍
Fasteners are
jammed in the tool
frequently.
Stop using tool immediately if any of the following problems occur. Serious personal injury
could result. Any repairs or replacements must be done by a qualified service person or an
authorized service center.
WARNING:
!
13
