CLEANING
If the screen gets dirty or smeared, clean it with a
clean cloth. If the
FS/2
gets very dirty, it should be
cleaned:
●
Make sure that the battery cap is tight. If you
have dropped it, check that the case and seals
are intact.
●
Gently rinse the unit under clean running water
(no more than hand hot, 40˚C). Do not immerse
the unit unnecessarily, or use a high pressure jet.
●
To remove stubborn deposits, use a soft bristle
brush and a mild detergent. TREAT THE
KEYBOARD GENTLY.
●
Blow any water out of the connectors, then leave
it to drain and air dry. DO NOT EXPOSE THE
UNIT TO TEMPERATURES ABOVE 55˚C.
●
Polish the screen with a clean cloth.
CAUTION: Do not use organic solvents or harsh
detergents, as they may damage the casing.
PERIPHERALS
CAUTION: Connect only approved cables and
peripherals to your FS/2
.
To connect a suitable peripheral to the
FS/2
:
●
Turn off the
FS/2
(and peripheral, if appropriate).
●
If fitted, remove the protective cap from the
appropriate connector.
●
Fit the peripheral to the connector.
●
Use connector locking mechanisms where fitted.
●
Turn on the
FS/2
(and peripheral, if appropriate).
To disconnect a peripheral:
●
Turn off the
FS/2
(and peripheral, if appropriate).
●
Disconnect the peripheral from the connector.
●
If provided with a protective cap, fit it to the
connector.
