Replacing batteries
●
Turn your
FS/2
off.
●
Remove the battery cap by using a suitable coin.
●
Do not allow rain or moisture into the battery
compartment.
●
Tilt the unit to slide out the batteries.
●
Slide the fresh batteries into the battery
compartment, positive end first. If you are fitting
AA size batteries, it is advisable to fit the packing
sleeve supplied with the
FS/2
.
●
Refit the battery cap. Seat it with finger pressure
first and make sure that it has engaged the screw
threads before tightening it with a suitable coin.
●
Turn on and check operation.
●
If you can’t turn on, contact your system provider.
●
After changing batteries, you
MUST
ensure that
the battery type, capacity and power
management are correctly set. (Refer to your
application’s user instructions.)
CAUTION: If you have changed from rechargeable
to non-rechargeable batteries, warn anyone you
give the unit to. Non-rechargeable batteries must
NOT be recharged. Always use batteries of the
same type and charge state - don’t mix fresh
batteries with used batteries, or rechargeable
batteries with non-rechargeable ones. Observe
the instructions printed on the battery. Replace
only with batteries approved by your FS/2
supplier. DO NOT FIT LITHIUM BATTERIES.
ATTENTION:
Dispose of or recycle used batteries
according to the manufacturer’s instructions.
Nickel-Cadmium rechargeable batteries must be
recycled, or disposed of properly.
CAUTION: BATTERY CHEMICAL LEAKAGE IS
CORROSIVE. In the unlikely event of battery
leakage, do not touch. In case of accidental
contact, flush immediately with running water.
