13
12
TROUBLESHOOTING
Stop using tool immediately if any of the following problems occur. Serious personal injury
could result. Any repairs or replacements must be done by a qualified service person or an
authorized service center.
WARNING:
!
Air leaking at trigger
valve area.
O-rings in trigger valve housing are
damaged
Replace o-rings. Check operation
of Work Contact Element(WCE)
Air leaking between
housing And nose.
Loose screws in housing
1.Damaged O-rings
2.Damaged to bumper
Tighten screws
1.Replace o-rings
2.Replace bumper
Air leaking between
housing and Cap.
1.Loose screws
2.Damaged gasket
1.Tighten screws
2.Replace gasket
1.Replace bumper
2.Clean drive channel
3.Clean magazine
4.Replace spring
5.Check fitting, hose, or compressor
6.Replace and lubricate o-rings
7.Replace o-rings
8.Tighten screws and fittings
9.Replace gasket
1.Worn bumper
2.Dirt in nose piece
3.Dirt or damage prevent fasteners or
pusher from moving freely in
magazine
4.Damaged pusher spring
5.Inadequate air flow to tool
6.Worn O-ring on piston or lack
of lubrication
7.Damaged O-ring on trigger valve
8.Air leaks
9.Cap seal leaking
Tool skips driving
fastener
PROBLEMS
POSSIBLE CAUSE(S)
CORRECTIVE ACTION
1.Lubricate nailer
2.Replace spring
3.Replace damaged internal parts
1.Tool not lubricated sufficiently
2.Broken spring in cylinder cap
3.Exhaust port in cap is blocked
Tool runs slow or has
loss of power
1.Replace guide
2.Use only recommended fasteners
3.Replace with undamaged fasteners
4.Tighten screws
5.Replace driver
1.Guide on driver is worn
2.Fasteners are not correct size
3.Fasteners are bent
4.Magazine or nose screws are loose
5.Driver is damaged
Fasteners are jammed
in tool
If within two years from the date of purchase, this Husky air tool product
fails due to a defect in materials or workmanship, please immediately
contact Product Support at
(8am to 5pm EST, M-F,
except normal Holiday).Do not return the air tool to the store. Please be
prepared to send the product, postage prepaid, along with a copy of the
dated first owner purchase receipt with the tool
model
to: PRIME
GLOBAL PRODUCTS, INC. Address: Ball Ground, Ga 30107. A
defective product will be promptly replaced with a new one of
e q u a l
o r
g re a t e r
v a l u e .
T h i s
w a r ra n t y
e x c l u de s
incidental/consequential
damages
and
failures
due
to
misuse,
abuse
or
normal
wear
and
tear. This
warranty
gives
you
specific rights, and you may also have other rights, which vary, from
state to state. Please call
for details.
1-866-676-8468
1-866-676-8468
WARRANTY
2 YEARS LIMITED WARRANTY