Husky C331H, Инструкция по использованию и уходу

Страница: 9 / 80

9 HUSKYTOOLS.com
Please contact 1-888-43-HUSKY for further assistance.
PACKAGE CONTENTS
Part Description
A
ON ( I )/OFF ( 0 ) Switch: Turn this switch in the “ON ( I )” position to provide automatic power to the
pressure switch and “OFF ( O )” to remove power at the end of each use.
B
Safety Valve:
If the pressure switch does not shut off the air compressor at its “cut-out” pressure
setting, the safety valve will protect against high pressure by “popping out” at its factory set pressure
(slightly higher than the pressure switch “cut-out” setting).
C Tank Pressure Gauge: The tank pressure gauge indicates the reserve air pressure in the tank.
D
Air Compressor Pump: Compresses air into the air tank. Working air is not available until the
compressor has raised the air tank pressure above that required at the air outlet.
E
Drain Valve : The drain valve is located at the base of the air tank and is used to drain condensation at
the end of each use.
F
Check Valve:
When the air compressor is operating, the check valve is “open”, allowing compressed
air to enter the air tank. When the air compressor reaches “cut-out” pressure, the check valve “closes”,
allowing air pressure to remain inside the air tank.
G
Thermal Overload Reset: (not shown) This motor has a manual thermal overload protector. If the motor
overheats for any reason, the overload protector will shut off the motor. The motor must be allowed to
cool down before restarting. To restart:
1. Place the ON/OFF switch in the “OFF” ( O ) position.
2. Allow the motor to cool.
3. Place the ON/OFF switch in the “ON” ( I ) position to restart the motor.
H
Regulator: Valve used to ensure that the tank pressure never reaches unsafe levels. It also allows the
user to adjust the pressure coming out of the tank to match what is needed for the task.
I
Pressure Regulator Gauge: The gauge that indicates the amount of pressure that the regulator is
providing to the tool.
J
Quick Connects: Fittings that are designed to accept a hose that allows pressure to be released for tool
usage.
A
E
B
I
C
H
D
F
J
SYSTEM COMPONENTS
Pre-Operation (continued)