8
9 HUSKYTOOLS.COM
Please contact 1-888-HD-HUSKY for further assistance.
NOTICE:
PLEASE READ BEFORE INSTALLING OR RISK DAMAGING HUSKY WALL
If there is a gap between two top rails end to end or bottom
rails end to end because of the dowel / e-clip you can counter
sink the hole 1/8” with a 3/8” drill bit.
Also if you are having trouble getting the dowels in any of
the dowel holes you can bore out any of the dowel holes
with a 3/16” drill bit.
If side rails don’t fit because the panel, top rail, or bottom
rail are too long use a saw to cut off extra length.
If your having trouble getting dowels into dowel holes by
hand you can tap dowels lightly with a hammer or mallet.
Call customer service at: 1-888-HD-HUSKY
Care and Cleaning
How do I maintain and clean my new organizing system?
Husky Track and Husky Wall are heavy-duty cellular PVC extruded from the very best virgin materials thatmaintains
its clean consistent finish. Simply clean with a mild household cleaner or feather duster.
Husky Track is made from the highest quality materials and maintains a clean finish. Simply clean with a mild
household cleaner or a feather duster to maintain your track system.
Troubleshooting
What surface can Husky Track or Husky Wall be installed over?
Existing plaster, drywall, and concrete walls. To install over concrete walls use firing strips or a concrete drill bit and
“tap con” flathead screws to attach the same way as you would into a stud wall (pre-drilling screw locations).
How do I install Husky Track or Husky Wall over brick wall?
One way is to purchase concrete screws (system comes with hardware for wood) these along with a hammer drill
should work.
A second way is to fir out the wall using 2” x 2” studs. Anchor the studs to the concrete wall, a preferred method
spacing them 16” off center. For added support when storing heavier items, we recommend installing a plywood
sheet over the recently installed studs to help support our panels.
Can I add more Husky Track or Husky Wall when needed?
Yes, you can add more panels to your existing system as your storage needs arise. On each completed end, it is
easy to configure connections that allow you to add additional panels as your needs change in the future.
Can I cut Husky Track or Husky Wall?
Yes, Husky Track or Husky Wall can easily be cut using a table saw or jig saw or a hand saw. For best results use a
slider saw capable of making 12” or longer cut. Use a 90-tooth blade for a clean finish and then add our trim.
To counter sink use:
3/8” drill bit
.
To bore use:
drill bit
.
