4
5 HUSKYTOOLS.COM
Please contact 1-888-HD-HUSKY for further assistance.
Installation - [For 2 Pack & 4 Pack]
1
Marking the height
□
Mark the desired height of the Husky Wall panel on
your wall.
2
Marking the length
□
Draw a level line at this point (start at stud) to the end
of where you want the track to stop.
3
Marking the studs
□
With a pencil, mark your stud locations on this
level line.
4
Installing the top rail
□
Place top rail (BB) just above the line (so you can see stud
marks). Make sure it is level and install screws (FF),
starting them into indented slots at each stud location.
5
Adding additional top rails
□
Continue adding more top rail (BB) across the desired line
until the top rail of the track is complete. Make sure you use a
dowel (DD) and retaining ring (GG) in the middle of each dowel
to connect each top rail together (If possible try to use ½ of
one stud for each piece of top rail). Lightly tap the end of the
top rail with a mallet to seat the top rail onto the dowel.
6
Installing the Husky wall panels
□
Now that your top rail (BB) is complete, use a level and
draw a line straight down each stud mark to just below
bottom of last panel that you will use for Husky Wall. Now
take each Husky Wall panel (EE) and slide into top rail (BB),
which will cover screws from previous steps.
Husky Wall Configurations
2-PANEL CONFIGURTAIONS
4-PANEL CONFIGURTAIONS
1x1
48.43”
9.06”
15.06”
96.43”
48.43”
48.43”
1x1
2x1
1x2
2x2
1x4
96.43”
48.43”
15.06”
27.06”
Please Note
: choosing this
configuration will leave you
with one (1) extra top rail and
one (1) extra bottom rail.
Please Note
: choosing this
configuration will leave you
with one (1) extra top rail and
one (1) extra bottom rail.
Note
: make sure
screw is flush
otherwise
Husky Wall
panel will
not fit properly.
BB
FF
BB
BB
DD
GG
BB
BB
EE
EE
BB
BB
