6
Installation (continued)
4
Install vertical J-trims
□
Cut the remaining J-Trim (B) into two – 48
1
∕
2
in. pieces.
□
Overlap the vertical J-trim over the horizontal J-trim and secure at the bottom by fastening into the studs using screws (BB).
□
The wide side should fasten to the wall as shown in inset A.
□
Fasten into the stud using one screw (BB) at the top of the trim as indicated by arrows below.
□
Measure the distance between left and right edges to confirm that the distance between them is 96 in.
5
Install first panel
□
Insert one side of the first panel (A) into the vertical J-trim (B) at one side.
Curve the panel slightly to insert into the J-trim (B) at the other side.
□
Ensure the panel (A) is seated into the horizontal J-trim (B) and is level. Using screws (BB),
fasten through the screw channel of the panel into each stud as marked, every 16 in.
□
The first and last screw in each panel should secure the panel and the trim to the stud.
Hook channel
DO NOT SCREW HERE
x 4
x 2
x 7
x 1
NOTE:
Do not drive screw through the hook channel.
Screw here
A
B
BB
BB
A
