Husky 1254-06, Руководство пользователя

Страница: 8 / 24

7
Figure 6
NORMAL STARTING
1. THE ENGINE WILL START ONLY WHEN P.T.O.
CONTROL LEVER IS IN "OFF" POSITION AND THE
CLUTCH/BRAKE PEDAL IS FULLY DEPRESSED.
2. Move choke lever all the way up (choke on ). Experience
will indicate need for more or less choking due to variations
in temperature, grade of fuel, etc.
3. Move throttle lever up about half -way.
4. Insert ignition key and turn to the right to start engine.
Release when engine starts.
LIMIT CRANKING (CONTINUOUS) TO A
PERIOD OF 30 SECONDS TO PREVENT
OVERHEATING OF THE STARTER. IF
CRANKED FOR 30 SECONDS, STARTER
SHOULD NOT BE OPERATED AGAIN FOR 60
SECONDS TO ALLOW TIME FOR COOLING.
5. Move choke lever down about halfway as soon as engine
starts. Gradually push all the way down as the engine
warms up. In normal operation, choke lever must be in off
(down) position for best engine efficiency and fuel
economy.
6. Move throttle lever up to full speed when operating
tractor.
7. To stop engine, turn key OFF (counterclockwise) and
place gear shift lever in NEUTRAL and set brake. Remove the
ignition key when the tractor is not in use, or left unattended.
If engine has been working hard let it idle several minutes
before shutting it off. This will allow engine temperatures to
normalize more rapidly, preventing overheating.
EMERGENCY STARTING
In the event of electrical failure, get in touch with your
DEALER for assistance in locating the trouble.
Should the battery be too low on power to start the unit, it
is always best to remove the battery and have it recharged.
1. Check P.T.O. lever (must be in OFF position), gear shift
(must be in NEUTRAL) and parking brake set.
2. When starting manually with a rope, remove "V" belt
from starter and engine pulley.
3. Wind the starter rope clockwise around the engine
starter pulley. See arrow Figure 7. Give a quick, steady pull
on the starter rope. Repeat if necessary, until engine starts.
Figure 7
STOP ENGINE BEFORE REINSTALLING
STARTER-GENERATOR BELT.
NOTE: Should jumper cables be used instead of a rop e
start, the following must be observed:
4. REMOVE CELL CAPS.
5. Connect ends of one cable to positive (+) terminal of
each battery. Connect one end of other cable to negative (-)
of "good" battery. Connect other end of cable to engine
block on vehicle being started. (NOT TO NEGATIVE TER-
MINAL OF BATTERY.)
6. Follow procedure outlined under Normal Starting.
7. Remove tractor battery and have it fully charged as soon
as possible.
8. After the battery is fully recharged and has been
checked, reinstall it in the tractor, connecting the ground
cable
last.
STARTING THE ENGINE