Huskie Tools REC-3610, Руководство по эксплуатации

Страница: 10 / 14

www.huskietools.com
10
TROUBLESHOOTING GUIDE
PROBLEM CAUSE SOLUTION
MOTOR RUNS, BUT THE
TOOL JAWS WILL NOT AD-
VANCE
Insufficient Hydraulic Oil
Consult Factory for Repair Ser-
vice
Air Block in Hydraulic System
Invert tool to allow air to rise to-
wards the top of the oil bladder
Defective Hydraulic Circuit
Consult Factory for Repair Ser-
vice
MOTOR RUNS, TOOL JAWS
ADVANCE, BUT WILL NOT
BUILD PRESSURE
Insufficient Hydraulic Oil
Consult Factory for Repair Ser-
vice
Defective Suction Valve or By-
pass Cartridge
Consult Factory for Repair Ser-
vice
MOTOR WILL NOT RUN AT
ALL
Defective Battery Charge or Replace Battery
Bad Contact or Loose Battery
Connections
Check all Connections and
Wires
Misaligned Switch
Check to Make Sure that Switch
is Properly Aligned with Trigger
Consult Factory for Repair Ser-
vice
TOOL JAWS WILL NOT RE-
LEASE
Tool Did Not Complete a Full
Cycle and Bypass
Press Trigger and allow Tool
to Bypass, Then Release Tool
Jaws
Connector is Jammed in Tool
Jaws
Press and Hold Release Trigger
While Prying Tool Jaws Apart
Release Trigger is Bent or Mis-
aligned
Consult Factory for Repair Ser-
vice