HUROM HJ SERIES, Руководство пользователя

Страница: 23 / 32

Insert the silicone brush into the spin-
ning brush.
Hold the wing so the longer part of inner wing face
upward (see Step
1
above).
Hold the outer wing
2
of silicone brush with your
thumb and index finger and insert the inner wing into
the groove of spinning brush.
Check the groove of the spinning brush
and the direction of silicone brush.
There are grooves to insert silicone brush in the spin-
ning brush.
Silicone brush has inner wing
1
and outer wing
2
.
As shown in the figure on left, position the silicone
brush so the ‘inner wing’ faces the spinning brush.
Pull the inner wing tightly into the spin-
ning brush.
Push the silicone brush in from the outside and pull
the inner wing into the spinning brush with the other
hand. (See figure)
Pull the silicone brush tightly into the groove on the
spinning brush. The unit may be damaged if it is op-
erated without being properly and fully assembled.
Make sure the silicone brush is placed firmly into the
groove by holding the top and bottom part of the
outer wing and pulling it up and down in opposite
directions.
www.hurom.com
l
19
ASSEMBLING THE SPINNING BRUSH
3
2
1
Brush
groove
Inner
wing
Outer wing
1
2
1
2
SPINNING BRUSH SILICONE BRUSH
Top
(longer)
Bottom
(shorter)
4PJ12242_V.01.indd 23 2013-07-12 오후 4:51:31