Hurco winmax, Руководство по программированию

Страница: 74 / 254

2 - 26 Basic NC G Codes
704-0115-307
WinMax Lathe NC Programming
Table 2–8. Thread Parameters
Threading Cycle Parameters (continued)
Parameter Parameter
Type
Definition
T Length Length of thread between the infeed move and
pullout move.
U
Clearance The X return clearance. Measured from the major
diameter. Default 0.1" or 2.54 mm.
V Cutting When set to 1, the depth per pass results in constant
volume removal per pass. When programming
constant volume, do not program a final depth
parameter (E) in the same block.
W
Clearance Z clearance. Measured from the start of thread.
Default 0.1" or 2.54 mm.
X
1
1. The interpretation of this parameter is not affected by the Radius/Diameter
Mode state (G07 or G08).
Turn/Face Turn: Radius at the start of the final thread cut at
the end of the infeed motion. Effective final pass
radius = X or minR.
Face: The X end position at Z Clearance (Z + J + W).
Z Length The Z end position at the start of the final thread
pass at the end of the infeed motion, or X Clearance
(T + Z = K).