Hurco winmax, Руководство по программированию

Страница: 106 / 254

3 - 8 Basic NC M Codes
704-0115-307
WinMax Lathe NC Programming
M31 - Increment Cycle Counter
M31 increments the cycle counter.
M32 - Increment Setup Cycle Counter
M32 increments the setup cycle counter.
M38 - Steady Rest Clamp
The Steady Rest device can be manually hitched to the Z-Axis to assist with movement of
the Steady Rest to the proper location. The position of the Steady Rest device is tracked
in order to avoid colliding with the tailstock.
A safety switch located on a bracket under the way cover also protects against the Steady
Rest and Tailstock colliding. If the safety switch is tripped, the machine will enter the
Emergency Stop mode.
This optional device is used with turning centers to hold long pieces of stock in the center
while cutting.
The position of the Steady Rest can only be tracked when moving the
Steady Rest with the Z-Axis. If the Steady Rest is moved manually
without the use of the Z-Axis, then the control will not be aware of
this new position for the Steady Rest which will either allow the
tailstock to possibly collide with it or improperly limit the motion of
the Z-Axis when hitched to the Tailstock.