Set tilt by unscrewing inner collar with soft key a
quarter of a turn. Move ball to desired angle and
retighten collar.
IMPORTANT: Do not over tighten inner collar.
Tighten only until it engages the ball and
becomes flush with the outer flange
ADJUSTING TILT:
REPLACING LED BOARD:
To replace LED undo inner collar with soft key. Bring the ball and
Heatsink down through the outer flange. Unscrew ball from
Heatsink. This will allow access to the replaceable LED board.
Replace board by undoing the 2 M2 cap screws and unplug.
To reassemble reverse these steps. Be sure TIR lens is centred in
the ball when tightening.
IMPORTANT: Do not over tighten inner collar. Tighten only until
it engages the ball and becomes flush with the outer flange
Do not water blast/jet wash this fixture under any
circumstances.
