INSTALLATION
12
Secure the Cords — Side Stack
■
Close the shade completely.
■
Attach the end cap.
➤
Loosen the screw on the end cap until it is fl ush with the top of the end cap.
➤
Holding the cords below the end cap, push the end cap into place on the end
of the headrail.
➤
The end cap may need to be tapped in place with
a rubber hammer.
■
Locate the two marks on the
front channel
of the
headrail. Hook the cord anchor in between the two marks.
■
Use the provided Allen wrench to tighten the cord anchor
to secure it to the channel.
IMPORTANT:
The three cords attached to the cord anchor will still have some slack. Final
cord adjustment to remove slack will be done later in these instructions.
■
Tighten the screw on the end cap into the headrail.
■
Proceed to “Operate the Shade” on page 14.
Secure the Cords — Split Stack
A single cord is shown in the illustrations for
clarity. Your shade will have three cords.
■
First, slide the cords up the back channel of
the split stack stop plate, placing them into
the circular holder.
■
Second, feed the cords into the front
channel.
Cord Anchor
in the Front
Channel
Tighten with
Allen Wrench
Headrail
Cut Away
Cord
Anchor
1
2
Stop
Plate
Cords from
Trike
