Bracket
Spacer
Flat Top
of Spacer
Installation
Bracket
End Mount
Bracket
2
Install the Blind
Mount the Headrail
• Tilt back the headrail and slide it into the bracket along the
sloped tab.
• Position the back lip of the headrail behind the rear leg of the
installation bracket.
• Tighten the locking screw to hold the rail securely in place.
End Mount Applications
End mounting is used when the headrail must span an open space —
an arched window opening, for example.
End Mount Bracket Attachment
• Attach the short side of the end mount brackets to the mounting
surface with two screws.
• Be sure the two end mount
brackets are aligned at the
same height.
• Attach the installation
brackets with screws
through the top two
holes on the end mount
brackets.
To remove the headrail, first loosen the locking screw. Then tilt the
headrail back and slide it out of the installation brackets.
Bracket Spacers (Optional)
Bracket spacers can also be used to add clearance. Two versions are
available:
1
/
2
” and
7
/
8
”.
• Attach the spacers to the installation brackets using the two screws
provided with each spacer.
• Then attach the installation brackets to the mounting surface with
screws through the two holes in the rear of
the bracket spacers.
• Use a carpenter’s level to check that the tops of the brackets are
aligned at the same height before tightening the screws.
Back Lip of Rail
Fits Behind Leg
Tab
Tighten Locking Screw
Headrail
Operate the Blind
Tilting the Slats
• After installation, tilt the slats from fully closed in one direction to
fully closed in the other.
Repeat three or four times to work all
components in place.
• For optimal closure, an extra twist of the wand is required to close
the slats tightly.
Raising and Lowering the Blind
• Pull the single cord down and toward the center to raise and
lower. The slats should be open when raising and lowering.
• Pull the cord to the outside to lock the blind in position.
• See the illustration at the top of the next column.
3
Complete the Installation
Attach the Wand Tilter
The tilt mechanism inside the headrail has a metal shaft that extends
beneath the rail. The wand tilter must be attached to this shaft.
Remove the plastic sleeve from the top of the wand, slide it over the
metal shaft, insert the wand hook over the hole in the shaft, and slide
the sleeve over the hook to complete the wand installation.
Attach Hold-Down Brackets (Optional)
Hold-down brackets may only be used with outside-mounted blinds.
• Fully lower the blind and completely open the slats.
• Mount the hold-down brackets to the outside mounting surface
with the bottom of the slot aligned with the center of the “D” in
the HunterDouglas logo on the bottom rail end caps.
• Screw the washer head Philips screws through the slot in the
bracket into the “D” in the end caps, leaving enough gap for the
screw to slide freely up and down the slot.
4
Plastic
Sleeve
Hook
Metal
Shaft
Slide
Sleeve
Over
Shaft
Hook
Through
Shaft
Slide
Sleeve
Over
Hook
Bottom Rail
End Cap
“D” At Bottom
Of Slot
Screw Into “D”
