HunterDouglas M40 TE, Инструкции и предупреждения по установке и использованию

Страница: 9 / 20

EN
English –
7
06. Use the Up and Down buttons again to move the awning to disconnect position “S”.
07. Press and hold the Up and Down buttons simultaneously and wait for the awning to complete two short movements: one up movement and (after a few seconds)
one down movement, until it stops again in the set position. Then release the two buttons.
04 03
06 05
02 01
07
THE
END
“ 0 ”
03
1
5
sec.
“ 1 ”
( )
S
“ 1 ”
5
sec.
2
5
sec.
1
“ 1 ”
( )
S
“ S ”
5
sec.
2
5.8 - Awning with MANUAL hook-up of fabric on opening: “FTA” function
“ 1 ”
( )
S
This function has been developed exclusively for awnings with a manual mechanism to block the canvas in the opening position (for
example the mechanism on awnings with straight arms, on arbour awnings etc.). The motor enables memorisation of only one hook-up position. If
the function is active, during closure the motor is stopped automatically as soon as the awning comes into contact with the blocking mechanism on
its route. To then release the awning, press the
Down
button, wait for the awning to reach limit position “1”, release the mechanism manually and
close the awning by means of the Up button.
Caution! - The “FTA” function can only be set after programming the limit position values “0” and “1”. When “FTA” is active, the “RDC”
function acts on the entire travel of the awning.
01.
Use the
Up
or
Down
button to move the awning to the point of mid-travel.
02. Press and hold the Up and Down buttons simultaneously and wait for the awning to perform a short movement, a pause and then a second short move
02 01
5
sec.
THE
END
1
1
5.9 - Deleting the entire memory
Caution! - This procedure deletes all data in the Con trol unit memory, including positions “0” and “1”.
01.
Use the
Up
or
Down
button to move the awning to the point of mid-travel.
02. Press and hold the Up and Down buttons simultaneously and wait for the awning to perform a short movement, after which release only one of the two buttons
03. With 3 seconds after the awning has performed the short movement, press the previously released button (in point 02) three times.
04. The release the other pushbutton.
Note – If cancellation is completed correctly, on activation of an up or down command, the awning will perform two short movements (= no limit position programmed).
02 01
x 3
03 04
THE
END
1