HunterDouglas M40 TE, Инструкции и предупреждения по установке и использованию

Страница: 8 / 20

EN
6
– English
03
5
sec.
02 01
04
5
sec.
THE
END
1
1
“ 1 ”
5.7 - Awning with AUTOMATIC hook-up of fabric on opening: “FTC” function
This function enables automatic connection and disconnection of the awning. The “FTC” function can only be activated if the automatic fabric connect/disconnect
mechanism is present on the awning, in a single position , located in alignment with the awning opening position. The motor enables memorisation of only one hook-
up position.
In general this type of mechanism has a stop for mechanical connection of the awning and two additional points (positioned beyond the stop) which the awning must
reach to enable connection (in position “
1
”) and disconnection (in position “
S
”) of the canvas.
Therefore to ensure correct operation of this mechanism, the two positions “1” and “S” must be set and memorised as described below.
“ 1 ”
( )
S
Caution!
• Before programming the “FTC” function, ensure that limit positions “0” and “1” have not been memorised; if necessary, cancel them according
to procedure 5.9. • Position “1” must be located a few centimetres be yond the mechanical connection stop. During opening. this will enable the
canvas to reach first position “1” and then hook up to the mechanical stop during ascent. • Position “S” must be located a few centimetres be yond
the disconnection mechanism. During closure, this will enable the canvas to reach first position “S”, automatically detach from the mechanical stop
and then raise to the closing limit position “0”.
• (The “RDC” function remains enabled)
01. Use the Up or Down button to move the awning to the point of mid-travel.
02.
Press and hold
Up
until the awning stops automatically at limit switch “
0
”; then release the button.
03. Press and hold Down and move the awning beyond the hook-up point, stopping it a few centimetres further than this point (if necessary correct the position using
the two buttons).
04. Press and hold the Up and Down buttons simultaneously and wait for the awning to complete two short movements: one up movement and (after a few seconds)
one down movement, until it stops again in the set position. Then release the two buttons.
05. Press and hold both the Up and Down buttons simultaneously until the awning performs a short up movement. Then release the two buttons.
06. Use the Up and Down buttons again to move the awning to disconnect position “S”.
07. Press and hold the Up and Down buttons simultaneously and wait for the awning to complete two short movements: one up movement and (after a few seconds)
one down movement, until it stops again in the set position. Then release the two buttons.
04
06
02 01
“ 1 ”
( )
S
03
5
sec.
5
sec.
05
“ 1 ”
( )
S
07
5
sec.
THE
END
“ 0 ”
2 1
2
“ 1 ”
“ S ”
• (It disables the “RDC” function)
01.
Use the
Up
or
Down
button to move the awning to the point of mid-travel.
02. Press and hold Up and wait for the awning to stop automatically at limit switch “ 0 ” (do not release the button!).
03. With the Up button still pressed, press and hold the Down button at the same time and wait for the awning to complete a short down movement; then release
the two buttons.
04.
Press and hold the
Up
and
Down
buttons simultaneously and wait for the awning to complete two short movements: one up movement and (after a few seconds)
one down movement, until it stops again in the set position. Then release the two buttons.
05. Press and hold both the Up and Down buttons simultaneously until the awning performs a short up movement. Then release the two buttons.