27
make a note of the new settings, since
when the battery is removed and a new
one installed, the transmitter will revert
back to the original settings.
Installing the Transmitter Battery
Your SRR Transmitter requires a 9V alka-
line battery. To install the battery, slide
open the battery door (on the back of the
transmitter), attach the battery to the clip,
insert the battery, and slide the door shut
again. (When changing the battery, push
the battery down in the case to reveal the
battery clip before attempting to remove
the battery from the case.)
Changing the Transmitter Address
Both the SRR Transmitter and Receiver
have an “address” that they use when com-
municating. If the addresses do not match,
the Receiver will ignore the transmission.
Your SRR comes from the factory with
both Transmitter and Receiver address set
to 0. You may change the address to any
value from 0-127 for added security. Note
that if you change the Transmitter address,
the Receiver must “learn” the new address
as described in “Preparing the Receiver for
Use” section.
To change the Transmitter address
follow the steps below:
1. If the unit is OFF (no display), power
the Transmitter by pressing any of
the buttons for at least 1 second then
releasing the button. The Transmitter
will first illuminate the entire display
for 1 second then display the active
station.
2. Simultaneously press the and but-
tons, until the word “RUN TIME”
along with the current Run Time is
displayed. The display will be blinking
at this point.
3. While the display is blinking and
showing the current Run Time, Press
the “ON” button. The word
“ADDRESS” will now illuminate and
the current address will be blinking.
Note that if more than 5 seconds go
by without a button being pressed, the
Transmitter will revert back to display-
ing the active station.
4. Use the and buttons to change the
address to any value between 0 and
127. Then do not touch any of the but-
tons for 5 seconds and the display will
stop blinking, and return back to the
active station.
Receiver…
Preparing the Receiver for Use
As stated earlier, your SRR System is
designed to work right out of the box. If
you have decided to change your Trans-
mitter address as described in the previous
section, you must allow the Receiver to
“learn” this new address. Once learned,
the only way to remove the address from
Receiver memory is to learn a different
address. This can be done by following the
simple steps outlined below.
Changing the Receiver Address
1. Hold down the single button on the
face of your Receiver while you are
plugging it into an active wiring har-
ness (one connected to a powered
controller). When this is done, the
Receiver will beep 4 times.
2. After the Receiver starts to beep,
release the button.
3. Press either the “ON” or “OFF” button
of your Transmitter.
4. The Receiver will beep 4 additional
times indicating that it has learned
the new Transmitter address and will
respond only to it from this point on.
RUNTIME
SRR Remote Control
Содержание Pro-C
Страница 35: ......
