9
1886
Note: The screw was installed for shipping purposes only.
Preparing the Light Fixture
Installing the Light Fixture Hood
Ceiling Bracket
Housing
Downrod
Hanging Fan
Wiring
Blades
Canopy
Light Fixture
Hood
Pull Chains
Glass/Cage
Repeat x2
Canopy Screw
Blade Screw
Blade Arm Screw
Remove the pre-installed fixture screw and red
flag from the light kit assembly.
Save the screw.
It will be needed for light kit installation.
IMPORTANT
Make sure the upper switch housing is securely
attached to the mounting plate. Failure to properly
secure all 3 assembly screws could result in the
switch housing fixture falling.
Follow these steps to prepare the light fixture for installation.
Red Flag
KEEP
x1
Fixture Screw
Remove and discard the
plastic connectors from the
ends of the two pull chains.
Carefully remove the light
fixture from the light fixture
hood and set the light fixture.
Partially install two fixture mounting
screws ,found in the
hardware
bag, into the motor housing as
shown. It does not matter which two
screw holes you choose.
Insert the third screw, found in the
hardware
bag, into place and then tighten all three screws.
Feed the wire plug through the center hole of
the light fixture hood. Align the keyhole slots
in the hood with the two screws you just
installed. Lift the hood so that the keyhole
slots engage the two screws, and twist
counterclockwise to lock the hood into place.
2 of 3
3 of 3
Fixture Mounting Screw
Fixture Mounting Screw
bag
bag