11
1886
Installing the Pull Chains
Installing the Glass and Light Fixture Cage
ON
Turn P
ow
er
Repeat x2
Feed the pull chains from the fan switch
and the light switch down through the
holes in the upper switch housing as
shown. Attach the pull chain pendants to
the light and fan pull chains.
The fan pull chain controls
the speed: from high to off.
The light pull chain controls
the light fixture: on and off.
Carefully lower the glass
into the light fixture cage
until it rests in place.
Install the third fixture
screw and tighten all
three screws securely.
Partially install two fixture screws,
found in the
hardware bag,
halfway into the light fixture as
shown. It does not matter which
two screw holes you choose.
Fixture
Screws
Fixture
Screws
Fixture
Screws
3 of 3
Fixture Screw
bag
2 of 3
Fixture Screw
bag
Align the keyhole slots in the
cage with the partially installed
screws in the light fixture. Lift the
cage and twist counterclockwise
to lock it into place.
Ceiling Bracket
Housing
Downrod
Hanging Fan
Wiring
Blades
Canopy
Light Fixture
Hood
Pull Chains
Glass/Cage
IMPORTANT
Make sure the globe assembly is securely
attached to the switch housing. Failure to
properly secure all three assembly screws
could result in the light fixture falling.