10
1886
Installing the Pull Chains
Installing the Glass and Light Fixture Cage
Installing the Light Fixture
3 of 4
Fixture Screw
bag
Partially install three fixture screws, found
in the
hardware bag, into the posts as
shown, leaving the circled post empty.
Fixture
Screw
Empty Post
Keyhole
Slot
Connect the plugs from the upper and
lower switch housings. Make sure to
line up the colored markings on the
connectors and that the connectors latch.
Align the three keyhole slots in the light
kit with the three assembly screws in
the posts. Lift the light kit and twist
clockwise to lock it into place. Be sure
that both pull chains are hanging freely.
Install a bulb into each of the
sockets. When necessary, replace
with bulbs of the same wattage.
Install the fourth fixture
screw and tighten all four
screws securely.
This is the screw you saved that
was attached to the red flag.
Fixture Screw
bag
4 of 4
Ceiling Bracket
Housing
Downrod
Hanging Fan
Wiring
Blades
Canopy
Light Fixture
Hood
Pull Chains
Glass/Cage
IMPORTANT
Make sure the lower switch housing is securely
attached to the upper switch housing. Failure to
properly secure all three assembly screws could
result in the light fixture falling.