Hunter IMMS-SI, Руководство по установке

Страница: 11 / 16

9
There are 4 different diagnostic modes available from the SI buttons.
The “A” button is used to select the diagnostic, and “B” is used to
execute it.
Run Station . Press and hold “A” for approximately 3 seconds, until
“d1” appears. Press the “B” button for 1 second, and station 1 at the
controller will run for 1 minute (checks communication between
interface and local controller).
Radio check . Press and hold “A” until “d1” appears. Release, and press
once again to display “d2”. Press “B” for one second. This will
cause the radio to transmit a continuous tone for 5 seconds (verifies
operation of radio, no effect in non-radio units).
Check Controller Interfaces . Press and hold “A” until “d1” appears.
Release, and press twice to display “d3”. Press “B” for one second.
The SI will now “poll” the CI’s in order to verify communications, and
each CI address will appear in the display. If a CI does not respond,
the display will alternate between the problem CI’s address and the
“EE” error display (troubleshoot communications and power to CI).
Press “B” once to stop polling and return to normal operations
(continuous “01” display).
Configure Modem Country Code . Press and hold “A” until “d1” appears.
Release, and press three more times to display “d4”. Press “B” for
one second. SI display will be c X, where X equals the country code
selection for the telephone modem according to the following table:
DIAGNOSTICS ...........................................................................................................................
The default setting is “c 0” and for most countries this is the correct
selection. If your country appears on the following list, change the code
display to the number shown:
Country Code
Australia 2 Israel 1 Poland 1
Czech Republic 3 Japan 4 Singapore 1
Hong Kong 1 North Korea 1 Slovenia 1
Hungary 1 Malaysia 1 South Africa 6
India 1 New Zealand 5 Vietnam 1
Indonesia 1 Philippines 1
Press “A” to select country code. When correct code is displayed
press “B” for 1 second.
Turn off or disconnect AC power plug before making any connections
inside the SI!
ADDITIONAL CONNECTIONS ................................................................................................